How to Install 110g Curly Clip-In Hair Extensions Follow

If your curly hair is fine or low in density, our 110g curly clip-in hair extensions are the perfect way to get a quick boost. Here is how to install Bebonia 110g Curly Clip-In Hair Extensions: 

Wash

1: Wet your curly clip-in hair extensions with lukewarm water until completely saturated. Apply shampoo, then rinse

2: Apply conditioner to your hands and rake it through with your fingers from top to bottom, then rinse with cold water

Styling Method #1

1: Hold up your curly clip-in hair extensions (start with one weft at a time)

2: Add lightweight, defining curl cream to your hands and rake it through the weft from top to bottom

3: Use a Denman brush to further distribute the product and help define the curls

4: Flip the weft over to add more volume to the top 

5: Rake your fingers through the curls and scrunch 

6: Diffuse for best results

Styling Method #2 (For Corkscrew Curls)

1: Lay your wet Bebonia curly clip-in hair extensions on a flat surface 

2: Apply a lightweight, hydrating cream by raking it through with your fingers from top to bottom

3: Brush the curls with a Denman brush

4: Use a quarter size amount of strong hold gel and rake it through the weft's curls

5: Use your finger to separate the weft in half—this will make styling easier

6: Take small sections of the hair and, using a makeup brush approximately the same size as your natural curls, wrap the wet ends of the curls around the brush for added definition (tip: wrap the hair around itself, creating a barrel)

7: Smooth the ends in and slide the curl off the makeup brush (do NOT twist the hair)

8: Dry the weft by leaving it on the table and hover over it with a diffuser. Wait until the hair is fully dry before moving it

9: Once dry, the curls will be tightly coiled. Lightly spray the curls and rake your fingers through the curls to loosen the curls for a more natural look

Visual learner? Check out the step-by-step instructions in our YouTube video: